§ 21-36. R-1, Single Family Residential—Large Lot.

(a)

Permissible Future Land Use classifications. The R-1 zoning district may be assigned to properties designated as Traditional Neighborhood Area and Residential—Low density on the City's Future Land Use Map.

(b)

The purpose of the R-1, Single family Residential- Large Lot zoning district is to provide areas for single-family, low density residential development with the necessary and incidental accessory uses that are normally located with the principal use. The maximum density permitted in the R-1 district shall not exceed three (3) dwelling units per gross acre.

(c)

Building form standards. All development within the R-1 zoning district shall follow the building form standards as set forth below in Table 21-36.

Table 21-36
R-1 Zoning District Development Standards

Lot and Building Standard		Requirement
Lot/Parcel Size	Area	Minimum 10,000 square feet
	Width	Minimum 85 feet
	Depth	Minimum 110 feet
Living Area		Minimum 1,000 square feet
Building Setbacks	Front	Minimum 30 feet
	Side	Minimum 5 feet
	Street Side	Minimum 25 feet
	Rear	Minimum 25 feet
Building Height		Maximum 35 feet
Impervious Surface Ratio		Maximum 60 percent

 

(d)

Other requirements:

(1)

Clubhouses and similar facilities are permitted on parcels retained by the developer or dedicated to and maintained by a homeowners association.

(2)

Home occupation uses are permitted as long as they are an activity conducted in a residential dwelling unit that employs on-site only members of the immediate family residing there. Specific regulations are contained in section 21-201 of this Code.

(Ord. No. O-00-09, Art. 2 (2.02.03.03), 4-24-00; Ord. No. O-17-40 , § 4, 10-23-17)